Emulsifying Machine Running Process Must Pay Attention To The Problem

  • Description
Product Detail

1. Homogeneous emulsifying machine cutting head due to the extremely high speeds, may not operate under empty pots, avoid local heating affects the seal level.

2. Reliable grounding ground wire to ensure electrical safety.

3. Homogenizer is seen from the reverse, after the motor wiring or disuse reinstated should move the Green run, turned to look down from the top to the mixing box reversal. Debugging dynamic mixing should be first tried to go, confirming Homogenizer again worked.

4. Each time stirs the start you have to move, check that the stirring wall scraper is an exception, if any should be immediately excluded.

5. Mixing vacuuming work, remember to check that the pot lid flat, Pan, outlet cover is covered, reliable sealing; always check the vacuum pump water tank, vacuum pump is running is not water!

6. Vacuum pump before the shutdown should be before the pump ball valve closed.

7. Vacuum pump in homogeneous pan seal below to start running. If you have special needs to open through the atmosphere to start the pump, operation should not exceed 3 minutes.

8. Must be cut off before performing any maintenance or cleaning devices are connected to the power supply.

9. No room for the operation of the equipment will be dipping into the pot to prevent accidents.

10. If different responses stop running immediately during operation, to examine the cause before the boot.


Send your message to this supplier
To:  

PED Chemical Machinery Co., Ltd.

* Content:  

For better quotations, include:

- A self introduction

- Special requests, if any

Quantity:  
  
You May Like
Not exactly what you want? One request, multiple quotations Get Quotations Now >>
China Mainland Favorites
Transaction Level:

* Quantity:

You May Like