T35-11 Axial Fan

I. Product Overview

 T35-11 axial fan is a new fan of the eighties in the 30-11 basis improved design, it has obvious advantages compared to 30-11 fans: ? structure is more reasonable; cylindrical hub, reducing the flow loss, high strength of the blade root; ? performance has improved greatly; total pressure efficiency was 89.5%, the noise reduction 3.6dB (A).

 This series of fans for conveying non-flammable non-corrosive gases no significant dust, ambient temperature must not exceed 60 ?, widely used in general factories, warehouses, offices, residential heating ventilation or strong heat, but also have a more over a long interval of exhaust pipe installed in series to increase the pressure in the pipe, remove the fan casing can be done freely.

 Second, product characteristics

 1, T35-11 axial fan impeller diameter steeled Thirty specifications, number of leaves each specification are four fan blade angle has 15 °, 20 °, 25 °, 30 °, 35 ° five kinds, a wide range of parameters, the amount of wind 826-67892m3 / h, pressure 39pa-474pa.

 2, T35-11-type axial fans are mainly impeller, housing, collector and motor and other components, the impeller and motor directly connected to the steering wheel L (motor end).

 3, corrosion axial fan (FT35-11) is the use of anti-corrosion motor, for the transport of corrosive gases.

 4, explosion-proof axial fan (BT35-11) also T35-11 derived products for the transportation of flammable and explosive places, the impeller is made of aluminum alloy processing to prevent sparks in operation, the motor is equipped with explosion-proof motor.

 Third, the product process

 1. Impeller: Baosteel produced blades made from high quality Q235 steel, metal cutting, hydraulic molding. Wheel Baosteel produced from high quality Q235 steel, hydraulic machine stretch forming. Leaves by special welding equipment welding protection of carbon dioxide gas. And by the significant number of hard-bearing balancing machine calibration, balancing accuracy G4.6 level and above.

 2, Hair Dryers: Baosteel produced from high quality steel with Q235 cutting shears, with three core Bending rounded, carbon dioxide gas welding. Spinning flow forming machine, beading machine spinning and then the two arc-shaped ribs on the barrel. Guarantee duct has sufficient strength, stiffness, elegant appearance.

 3, the safety net: fan with a galvanized protective grille.

 4. Assembly: After the fan assembly, X, Y, Z axis vibration velocity is less than 5.6mm / s.