Special Paint

Min Order

1
Product Unit

Pieces
Origin

China Mainland
Payment
Contact Now Start Order

Description

Product Detail

725-W61-22 Organo silicone high-temperature resistant paint-Silver

Product Description

-One pack, dry at room or higher temperature

-On surface likely to reach up to 300~600?

-VOC less than 535g/L

Intended Use

-For use at all kinds of high temperature equipment

-For use petroleum pipeline or oven.

Product Information	Volume Solids	40%±2%
	Finish/Sheen	Gloss
	Typical Film Thickness	30microns dry (75microns wet)
	Theoretical Coverage	13.3m²/L at typical film thickness
	Mix Ratio	One pack
	Method of Application
	Airless Spray	Recommended
		Tip size range		0.38-0.53mm
		Output pressure		=17MPa
	Air Spray	Tip size range		2.0-3.0mm
		Output pressure		=0.4MPa
	Brush/Roller	For small area only
	Thinner	Not recommended. Use only in exceptional circumstances (volume 5%)
	Cleaner	JX-601
	Induction Period	Not applicable
	Drying Information
		10?	25?		35?
	Touch Dry	1h	30min		20min
	Hard Dry	8h	6h		3h
	Pot Life	Not applicable
	Overcoating Data Substrate Temperature
	Overcoated by	10?	25?		35?
		Min Max	Min Max		Min Max
	725-W61-22	8h	6h		3h
	Storage	Store in cool and dry conditions. Well ventilate. Keep away from hot and fire. Shelf Life: 12 months minimum at 25?. Subject to re-inspection thereafter.
	Pack Size	21.6kg/18L in 20L container
	Flash Point	Greater than 28?
urface Preparation	All surfaces to be coated should be clean, dry and free from contamination. Abrasive Blast Cleaning Abrasive blast clean to Sa2½(GB/T8923.1-2011). If oxidation has occurred between blasting and application of 725-W61-22, the surface should be reblasted to the specified visual standard. Surface defects revealed by the blast cleaning process should be ground. Filled, ortreated in the appropriate manner. Repair The areas to be repaired should be cleaned to St3(GB/T 8923.1-2011)by mechanical method or higher level of surface prepared to Sa2.5(GB/T 8923.1-2011)by abrasive blasting. Abrade the area immediately surrounding the repair to provide a key for subsequent coating application. Overlap areas should be kept to a minimum.
Limitations	Apply in good weather. Temperature of the surface to be coated must be least 3? above the dew point when the humidity is lower than 85%. The dry time and overcoating interval may change according to the environment factors. Avoiding absorb the solvent steam and paint steam for long time. Skin and eyes must avoid contacting the paint. Pay attention to ventilate and fireproof when applying.
Duty statement	The data in the sheet base on the information from the laboratory and practice. The application may exceed the control, so we only ensure our product quality. We own the right of the data sheet modification without informing.