Polishing Mixed Bed

1 polishing resin is produced by hydrogen type strong acidic cation exchange resin and hydroxyl type and strong basic anion exchange resin mixed.

2 in the operation, such as the need to add water to facilitate loading, please note must use pure water, water is not too much, at the same time must be in the resin into the resin tank immediately after the water out or discharged, to avoid the resin layer. If you need to fill in the resin, please be sure to wash the hands, do not put oil into the resin tank.

3. Like to dress up resin, must complete cleaning barrel groove and a water collector, there shall be no old resin residue at the bottom of the groove, otherwise the use of resin will pollute the water quality.

4 every time when replacement must check the components, if damaged, should be replaced immediately. Check the collector, such as blocking, should be clear.

5 using the FRP bucket as the resin bed, should first set the pipe in the barrel of the tank, then loaded resin. In the process of filling the resin, should not set the timing of the water pipe, so in the end, to adjust the location of the water pipe and install the cover.

6. The resin filled and connect the pipeline, should first open the tank at the upper end of the vent and slow pass into the water, until the ventilation hole overflow and no air bubbles through stomata closed, began to produce water.