T-200K Computer Connected LED Controller

Shenzhen Oxford Lighting Co.,Limited is one of the professional t-200k computer connected led controller manufacturers and suppliers in China, welcome to wholesale t-200k computer connected led controller made in China and check its price with our factory.

1.T-200k System features

1.32—256 Gray level,Support software Gamma correction?

2. Support the rules and special-shaped handle.

3. 8 ports output,one port can support 512-1024 pixels?

4. offline (SD card) control and on-line control can be combined using multiple controllers, the contents of the offline control program stored in the SD card.

5. Compatible with single line or double line chips.

6. If the controller to the lamps distance can choose photoelectric isolated transmission and as far as several distances of up to 200-300 M

Remark:T-200K Off-line(SD Card) control need to be the first master controller insert SD card.

T-200 K in the PC software compatible with T-100 K-B 

NOTE:1. When T-200k controller control less than 512 lamps the frame rate can reach 30fps. When T-200k control more than 512 lamps and less than 2048 lamps the frame rate will slow down automatically.

2. T-200k must use the new software LedEdit 2012.

2.Support chips:

NOTE:if chip is 256 grade gray level and Single-line IC choose .When programming choice high speed mode and one interface controls 1024 lamps the play speed can reach 30 frames/s. Double-line IC or single-line IC with low speed , one interface controls 512 lamps the play speed can reach 30 frames/s.

3.Appearance picture

4.The meaning of flag

TTL signal(245 signal):

NOTE:According to TTL signal output,Ground of the controller must be connected to the lamp’s ground.

5.System architecture figure

Note:The IP address of the computer should be set to: 192.168.60.178

6. Application scope

LED digital tube,?LED point light source?the exterior light and a module? pixel screen (dazzle colour screens)? high power DMX lighting.

7.Specific parameters:

Memory card:

Type:SD card(if controlling so many lamps it is best to use the high-speed SD card.)

Capacity:128MB—2GB

Format:FAT

Store file:*.led

8.Physical parameters:        

Working temperature :-30?—85?                   

Weight:1.35KG

Working voltage:AC220V

Working power:8W

Size:L270mm×W180mm×H55mm 

Signal port:3pin connect port

NOTE: T-300K Support online download the effect-file to SD card.

Attention:

T-100K-B outline controller. if many controller be used at the same time, the first controller must inset a SD card with one file only!

Before copy files to SD card ,The SD card must be formatted as FAT format.

The SD card in controller can not be hot-swappable, plug the SD card every time, you must first disconnect the power supply