Rod Type Oil Mill Machine 6YL-110T

Application:

This rods type oil mill machine is a new type oil press comparing to ring type oil press, it's especially used to press peanut with hull and especially good for rice bran pressing, it also can be used to press rapeseeds, sesame, sunflower seeds, etc.

Main data:

6YL-110T oil mill machine of rods:

Rods installing drawing:

Installment of screw: 

Mounting pressing screw: Put small end of the central shaft upwards,mount the six screw and then the five, four, three, two, one sequencially (Note:Add several circles of cotton thread or waterproof tape on each side of the shaft from the third screw to jam the space between the shaft hole and central shaft,which may keep the center from oil leak), then tighten them by the lock nut to avoid particles in. The one side close locknut is 8309 bearings and the other is 8309, it should be installed the same as the original. Finally, whole pressing screw will be tightened by round nuts with hexagon nut,and gaps between round nut and bearing side would be set at about 0.3-0.7mm(If adjusting bolt can be swung smoothly by hands, the adjustment is acceptable).

6YL-110T oil mill machine package:

If you're looking for the rod type oil mill machine 6yl-110t, welcome to buy the quality and cheap rod type oil mill machine 6yl-110t with us. We are one of the professional press machine manufacturers and suppliers in China. We will also offer you the wholesale service at big discount.