Metal Forming

  • Description
Product Detail

The technology uses punches and dies to produce the desired shape. Punch can be either mechanical drive, can also be hydraulically driven, but the hydraulic deep drawing is the best, because hydraulic punch on the stroke length can provide full pressure.

Most traditional technologies can be used for forming of stainless steel, but don't forget, stamped stainless steel force required than stamping required the strength of low carbon steel 60%. Apparently, punch of the rack should be able to withstand so much force it. Moreover, solving scratch is also crucial, especially from high friction and stamped stainless steel scratches caused by the high temperature. Common poor SOAP solution or emulsion effect, consultations should be conducted. If you are using a UHV (EP) additives for oils, after forming in the additive should be removed, because the chemical can cause corrosion.

Due to the high cost of tooling, so using this technique only for mass production.


Send your message to this supplier
To:  

SER technology limited

* Content:  

For better quotations, include:

- A self introduction

- Special requests, if any

Quantity:  
  
You May Like
Not exactly what you want? One request, multiple quotations Get Quotations Now >>
6 YRS SER technology limited
China Mainland Favorites
Transaction Level:
Contact Us

* Quantity:

You May Like