Dewatering Unit

MDS101 dewatering unit introduction

MDS101 dewatering unit belongs to the screw press, it's clog-free and can reduce the sedimentation tank and sludge thickening tank, saving the cost of sewage plant construction. MDS101 dewatering unit using screw and the moving rings to clean itself as clog-free structure, and controlled by the PLC automatically, it's a new technology that can replace the traditional filter press like belt press and frame press, the screw speed is very low, so it cost low power and water consumption in contrast to the centrifuge, it is a cutting edge MDS101 dewatering unit.

MDS101  dewatering unit specification

MDS101  dewatering unit running conditions

MDS101 dewatering unit replacement time of vulnerable part is a estimated time, in the actual operation process, the types of sludge, the means of processing, operation adjustment status and the running of the day, will affect the replacement time. (Replacement cycle of vulnerable part is calculated as 365 days per year, 8 hours/day of running time.)

MDS101 dewatering unit flow chart

MDS101 dewatering unit application

MDS101 dewatering unit can be widely use in municipal wastewater, wastewater food and beverage processing waste water,  oil processing and mining , chemical waste water, papermaking wastewater, industrial wastewater, etc.

MDS101 dewatering unit FAQ

Question 1: Will your machine be clog? What happened How reversal? What is the principle? Whether the machine has an impact

Lifeng company from the purchase of raw materials, are the use of domestic cold-rolled flatness of the better manufacturers, such as TISCO and Zhang Pu's SUS304, each piece of ring must go through mechanical and manual two procedures, which can be the greatest degree Reduce the clogging of the stacking machine. The stacker is not easy to block relative to the centrifuge and the belt, but it is sometimes unavoidable to clog due to uneven material and operation. The general logistics can be blocked by the reverse plug to deal with reversal, please turn the reverse button can be activated. If the laminated deformation occurs, you need to contact the manufacturer, disassemble, replace the stack.

Question 2: other manufacturers are using carbonization treatment, why do not you?

"Carbonization" is not carburizing? The purpose is to harden and strengthen the metal surface. Our machine is made directly by TISCO stainless steel manufacturers, we call 304 hard board. The processing of the steel mills is more professional than the stacking machine manufacturers themselves. As far as I know, the domestic only TISCO stainless steel can be done after the cold-rolled plate cauterizing treatment dickers hardness can reach HV380-420, other large manufacturers also reached HV250 or so, How much of other manufacturers can reach the hardness of the treatment be? Professional things to professional people to deal with, this is a professional attitude.

Question 3: the Government asked our company to discharge water to ss = 500mg / L, your equipment can not be achieved?

This need to be tested to determine.