Cylindrical Gear Reducer

1, cycloid reducer output shaft installation of couplings, pulleys, sprockets and other union members will not allow the selection when direct thump way, because of the layout of the output shaft cycloid reducer shaft unacceptable thump force to be used screw screwed into the screw shaft pressed into joint pieces.

2, shaft and output shaft input shaft selection GB1568-79 cooperation.

3, screw rings cycloid machine with only lifting gear.

4, when the foundation unit cycloid reducer, calibrate equipment cycloid reducer centerline elevation, levelness and linked some of the associated scales. Mounted concentric alignment of the drive shaft coupling should not exceed the agreed scale. )

5, cycloid reducer school on time, can be steel or cast iron pad pad conducted at the height of the pad side does not exceed three, were also available for lease of iron, but the cycloid reducer calibration should be swapped flat pad.

6, pads and equipment should cause the body to prevent deformation of foundation bolts shall be two symmetrically placed, its distance from each other to meet the irrigation water slurry when free circulation.

7, grout irrigation should be dense, no bubbles, open spaces and other shortcomings.