Cf Series Hammer Mill

Introduction of the CF series A Hammer mill

Hammer mill is the most ideal milling eqipment of all kinds of wood piece,straw,grass,stalk,three branches waste cardboard, bamboo, wood scraps,corn stalk,peanut shell,wheat stalk,wood fuel, cotton stalk, biomass shell and so on.

This kind of hanner mill is widely used in foddor factory, swine farm, wood factory etc.

Hammer mill is equipped with high carbon steel blade. The raw materials can be crushed into straw particles which diameter is 3-5 mm.

The durable hammer mill works with high efficiency and gains more good reputation from all over the world.

The function of the hammer mill

The hammer mill is fixed with an engine with a power of diesel engine or gasoline engine. Its working principle is: after the raw materials were put into crushing chamber, the high-speed operated hammer sheets will impact the raw materials over and over again, then the raw materials will be crushed into pre-set size step-by-step. The sieve have the following size: 1.5mm, 2mm, 4mm and 6mm. Then the crushed materials will leak out from the sieve. The draught fan will convey the leaked materials into separator centrifuge, finally, the powder will be discharged down below, and the air will be discharged upper.

Specifications of the hammer mill

Features of the hammer mill

1. Driven by a diesel engine makes materials crushing possible especially in the rural area with shortage of electricity.
 2. The rotor of hammer mill operates at 3,500 RPM to produce high hammer tip speed, thus the finished powder can be uniform with the least size.
 3. The core part -the hammers are made of high quality carbon alloy steel, which is durable and wear-resistant.
 4. Available screen discharge area can be up to1904 square centimeter which allows for high throughput at a lower horse power.
 5. Equipped with air blower, the crushed material can be directly collected and transported to next machine for further processing.
 6. You can change screening sieve according to different material grinding requirements.
 7. We can customize the following sieve with screening hole diameter of 1.5mm-10mm.