Weld On Pipe Caps

Weld On Pipe Caps
Steel pipe weld on pipe caps.The pipe cap is used to close the pipe, and the function is the same as the pipe block. The tube cap includes a convex tube cap, a conical shell, a variable diameter section, a flat cover and a tightening port design. From the point of view of the force of the convex tube cap from the hemispherical tube gradually bad, but from the manufacturing difficulty, gradually good manufacturing. Stitching distance should be required for greater than 3 ?, and not less than 100mm (weld heat affected zone is a high stress zone, and the chemical composition in the area will be burnt.) Finally, the weld seam detection level and proportion are the same as that of the equipment shell, which is high waste.The purpose of a pipe cap is to weld the pipe at the end of the tube or on the outer thread of the pipe end to cover the pipe. Used to close the pipe, the same effect as pipe plugging.

Characteristics:
1, health, non-toxic: This product is a green building materials, can be used in pure drinking water piping system.
2, heat resistance: under the prescribed long-term continuous working pressure, the water temperature of the pipeline can reach 95 ?.
3, corrosion-resistant, not scaling: can be exempt from the pipeline fouling and water basin, bathtub macular rust worry.
4, heat preservation energy-saving: thermal conductivity is only metal.

A pipe cap is a pipe fitting that is welded at the end of the tube or on the outer thread of the pipe end to cover the pipe. Used to close the pipe, the same effect as pipe plugging. Generally used in the pipe at the end of the sampling mouth, after the completion of the sampling, to screw the cap, the other is in special cases, the tube after the screw, you can connect the pipe, the temporary continuous picking or pumping material. With a pipe cap generally in the case of low pressure, easy to disassemble and overhaul, high school pressure in the case of general use no pipe cap.