Hot Sell Good Quality Metal Turnbuckle Nylon Female Rod End

Joint bearing can bear a large load. According to different types and structures, the bearing can bear a radial load, axial load or both radial and axial loads. Because the spherical outer surface of the inner ring is embedded with composite material, the bearing can generate self-lubrication at work. It is generally used in low speed swing motion, and can also tilt in a certain angle range; where the nonconcentricity of the supporting shaft and shaft shell hole is big, the bearing can still work normally. Self-lubricating joint bearing is used in water conservancy, professional machinery and other industries.

Characteristics: abrasion resistance, self-aligning, and low friction; suitable for low speed and heavy-duty mechanical structure.

MXM: (race: Nylon) (Cases: MXM6, MXML6)

1) Material:
Housing - 4130 Chrome - Moly
Heat Treatment: 1570*F for 1 hours, then water quench, then tomper at 900*F for 2 hours. Must test to 108 Rockwell B.
Finish: Bright pclished Chrome Plated.
Race - Nylon Molded. Tyoe 6/6, 40% Long Glass with 5% Molybdenum Disulfide.
Ball - 52100 Bearing Steel, Precision ground. Heat Treated Rc56 Min.Finish.Hard Chrome Plated.
2) Do not scale drawing.
3) Unless otherwise speated.all dims are in mm.
4) NO pressed in COM Bearing.
5) Must have minimum radial static lead of as listed in chart.
6) Ball must be centered after molding within ±0.05mm of the center line axis of the housing.
7) Slotied Nylon Design NO Tefbn allowed.

MXF: (race: Nylon) (Cases: MXF5, MXFL5)

A=BALL l.D
D=Nylon Slot Height
E=BALL O.D
å=Minimum Cone Angle of Ball.

1). Material:
Housing-4130 Chrome-Moly
Heat Treatment: 1570°F for 1 hours, then water quench, then temper at 900°F for 2 hours.
Must test to 108 Rockwell B (HRC 34).
Finish: Bright Polished Chrome Plated
Race-Nylon Molded, J-4-30-TF-13-Sl-2; 6-12 Short Fiber, Black (PTFE=8.6%, Short glass 34%)
Ball-52100 Bearing Steel, Precision ground, Heat Treated. Finish:Hard Chrome Plated
2). Do not scale drawing.
3). Unless otherwise specified, all dims are in mm.
4). No pressed in COM Bearing.
5). Must have minimum radial static load of as listed in chart.
6). Ball must be centered after molding within ±0.05mm of the center line axis of the housing.
7). Slotted Nylon Design; NO Teflon allowed.
8). Breakaway Torque for ball & Min Radial Static load must be as listed in this drawing.
9). Remove Burrs and Sharp Edges.
10). Dimensions apply after plating. Plating must withstand 96hr of salt spray test per ASTM B117 without any visible red rust.
11). Ball End-Play=0.05mm Max. Ball ln-Out Play=0.08mm Max.
12). See Letter dimensions and corresponding tolerances on separate chart.

Wuxi Jinwei Precision Machinery Co., Ltd
Mob: 0086-13906170913
Tel: 0086-510-83951313
Fax: 0086-510-83958913
Add:Yangshan Town, Huishan District, WuxiCity, Jiangsu Province
Email: sales@wxjinwei.com
Website: http://www.wxjwbearing.com